Close-up of worn industrial gearbox gears coated in oil

Steel Uncoiler Gearbox: Industrial Gear Oil Viscosity Stabilised

Industrial gearbox oil on a steel uncoiler: viscosity stabilised and 99% fewer large particles in 27 days.

Close-up of worn industrial gearbox gears coated in oil
case study

How a 27-day trial stabilised industrial gearbox oil and won a plant-wide rollout

The Challenge

A rolled steel processing plant in the United States ran an uncoiling gearbox from a 90 US gal (approximately 341 litre) reservoir of EP 320 gear oil. Laboratory analysis found heavy oxidation, excessive varnish and unstable viscosity. At 306.9 cSt, the measured viscosity raised concern over reliable lubricant film formation on heavily loaded gearing.

Moisture was considered a likely contributor, and high particle counts with an MPC value of 39.5 confirmed a substantial solid and oxidation-related contamination burden.

The Solution

A Delta-Xero offline filtration system ran a 27-day proof of performance trial, circulating the reservoir oil through submicron cellulose media to remove fine particles, moisture and varnish-related material while retaining the EP 320 additive package.

The trial tracked viscosity at 40°C, MPC and particle counts at ≥4, ≥6 and ≥14 µm, to find out whether the existing oil could be stabilised and whether permanent filtration would justify wider deployment.

The Results

  • Viscosity stabilised: from 306.9 to 333.7 cSt (an 8.7% recovery), back within specification.

  • Particle control: ≥4 µm particles down 95%, ≥6 µm and ≥14 µm down 99%.

  • Varnish potential: MPC reduced from 39.5 to 24.1 in 27 days.

  • Asset protection: estimated component life extension of more than 3.5 times.

  • Plant-wide rollout: the system was installed permanently and the customer began fitting filtration to main reservoirs across the facility.

Download the full industrial gearbox oil case study for the complete trial data.

Related Case Studies

About us - Delta-xero

Reduced iron levels and lower PQ index

A 1.5 MW wind turbine gearbox showed persistent contamination risk despite routine oil analysis. To understand the true internal condition of the gearbox, debris captured inside an offline filtration unit was analysed after extended in-service operation. Standard oil samples alone were not showing the full extent of varnish, wear debris, and moisture present within the system.  

View Case Study
Off-shore Oil and Gas: Case Study 2

The Additive Myth Debunked

A long-term independent study was carried out by POLARIS Laboratories Europe to assess whether installing Delta-Xero filtration on a landfill gas engine would negatively affect lubricant condition, additive performance, or expected oil drain intervals.

View Case Study
contact us

Ready to transform your oil management?