Coils of sheet steel stacked in a steel processing plant

Sheet Steel Slitter: Why a Hydraulic Oil Change Wasn’t Enough

Why a hydraulic oil change wasn't enough: over 99% fewer particles and 81% lower MPC on a steel slitter.

Coils of sheet steel stacked in a steel processing plant
case study

How offline filtration removed the contamination an oil change left behind

The Challenge

A confidential sheet steel processing plant ran a slitter from a 1,500 US gal (approximately 5,678 litre) reservoir of AW 68 hydraulic oil. Airborne carbon dust entering the hydraulic system caused abrasive contamination, excessive wear and repeated component rebuilds. The site had invested around $1.5 million in rebuilds and system improvements, yet operation and production scheduling stayed unreliable.

A recent oil change gave a misleading appearance of cleanliness. MPC stayed elevated because stagnant contamination and sump residue had not been removed, so retained varnish and carbon recontaminated the fresh oil.

The Solution

A Delta-Xero offline filtration system circulated the reservoir oil continuously through submicron cellulose media, targeting fine carbon dust, wear debris, moisture and varnish held in the reservoir and returning from the circuit.

Treatment ran for approximately one month, with final particle data at day 33. MPC, particle concentrations, ISO cleanliness and relative humidity were monitored throughout.

The Results

  • Over 99% fewer particles: every particle size band improved by more than 99%.

  • Varnish removed: MPC fell from 27.5 to 5.3, an 81% reduction.

  • Cleaner oil: ISO cleanliness improved from 20/19/16 to 11/8/7.

  • Less moisture: relative humidity fell from 52% to 30%.

  • Longer component life: the cleanliness improvement indicated more than ten times estimated component life.

Replacing the fluid alone cannot remove contamination held in sumps, pipework and component surfaces. Download the full sheet steel slitter case study for the complete data.

Related Case Studies

About us - Delta-xero

Reduced iron levels and lower PQ index

A 1.5 MW wind turbine gearbox showed persistent contamination risk despite routine oil analysis. To understand the true internal condition of the gearbox, debris captured inside an offline filtration unit was analysed after extended in-service operation. Standard oil samples alone were not showing the full extent of varnish, wear debris, and moisture present within the system.  

View Case Study
Off-shore Oil and Gas: Case Study 2

The Additive Myth Debunked

A long-term independent study was carried out by POLARIS Laboratories Europe to assess whether installing Delta-Xero filtration on a landfill gas engine would negatively affect lubricant condition, additive performance, or expected oil drain intervals.

View Case Study
contact us

Ready to transform your oil management?