Aerial view of a landfill site with a gas engine compound

Landfill Gas Engine: Oil Change Interval From 250 to 600 Hours

Gas engine oil on a landfill gas engine: oil changes from every 250 to every 600 hours, and decokes from 2,500 to 5,000 hours.

Aerial view of a landfill site with a gas engine compound
case study

How DX Powertrain filtration broke the wear cycle in a landfill gas engine

The Challenge

A confidential UK landfill gas operator runs a reciprocating gas engine at Finmere, Oxfordshire, on EXOL Taurus Geo LFG 240 (SAE 40) oil. Landfill gas is one of the most contamination-intensive environments in power generation. At baseline the engine oil was severely contaminated: against a standard 50 ml test volume, patch membranes saturated at just 4–5 ml.

Three wear modes were active at once: severe sliding wear, three-body abrasive wear driven by silicon ingress, and early-stage fatigue wear. They reinforced each other, putting the engine in an uncontrolled degradation cycle.

The Solution

A DX Powertrain DX1006-T-C-PT system was installed in a continuous offline kidney loop to remove contamination and break the wear cycle.

Oil condition was monitored at four stages (baseline, 329, 508 and 667 hours) using patch membrane microscopy, ferrographic wear particle analysis and ISO 4406 particle counting, with duplicate ISO tests at the final stage to confirm repeatability.

The Results

  • Longer oil change interval: from 250 to 600 hours.

  • Decoke interval doubled: from 2,500 to 5,000 hours.

  • Wear modes eliminated: severe sliding, three-body abrasive and early fatigue wear were all gone by 667 hours, leaving only mild rubbing wear.

  • Exceptionally clean oil: duplicate ISO 4406 results of 19/16/10 and 19/16/8, from a saturated patch at baseline.

  • Sustained improvement: consistent progress across all four assessment stages.

Download the full landfill gas engine oil case study for the patch and ferrography evidence.

Related Case Studies

About us - Delta-xero

Reduced iron levels and lower PQ index

A 1.5 MW wind turbine gearbox showed persistent contamination risk despite routine oil analysis. To understand the true internal condition of the gearbox, debris captured inside an offline filtration unit was analysed after extended in-service operation. Standard oil samples alone were not showing the full extent of varnish, wear debris, and moisture present within the system.  

View Case Study
Off-shore Oil and Gas: Case Study 2

The Additive Myth Debunked

A long-term independent study was carried out by POLARIS Laboratories Europe to assess whether installing Delta-Xero filtration on a landfill gas engine would negatively affect lubricant condition, additive performance, or expected oil drain intervals.

View Case Study
contact us

Ready to transform your oil management?