Injection moulding machine with mould tool and hydraulic lines

Injection Moulding Press: 93.5% Less Varnish in 17 Days

Injection moulding hydraulic oil: 93.5% less varnish in 17 days, chatter eliminated and cycle time restored.

Injection moulding machine with mould tool and hydraulic lines
case study

How offline filtration restored valve performance on an automotive moulding press

The Challenge

An automotive injection moulding machine in the United States developed audible chatter, valve sticking and progressively slower cycle times. Its 250 US gal (approximately 946 litre) reservoir held AW 46 hydraulic oil that had not been changed or topped up for more than three years, so oxidation products and fine contamination had built up.

The symptoms reduced throughput, increased rejected parts and created elevated pressure and vibration in the hydraulic system.

The Solution

A Delta-Xero offline filtration unit circulated the reservoir oil continuously through submicron cellulose media, targeting varnish precursors, fine particles and moisture so the oil could be recovered rather than replaced.

Laboratory measurements tracked MPC, particle counts at ≥4, ≥6 and ≥14 µm, ISO cleanliness and relative humidity, comparing the starting oil with a sample taken after 17 days.

The Results

  • Varnish removed: MPC fell from 70.8 to 4.6 in 17 days, a 93.5% reduction and comparable with new oil.

  • Fewer particles: ≥4 µm particles fell by 95%, ≥6 µm by 90% and ≥14 µm by 93%.

  • Cleaner oil: ISO cleanliness improved from 20/16/10 to 13/10/7.

  • Less moisture: relative humidity fell from 34% to 14%.

  • Production restored: chatter was eliminated and normal cycle time returned, with an estimated component life extension of more than six times.

Case study supplied by Kimbro. Download the full injection moulding hydraulic oil case study for the complete data.

Related Case Studies

About us - Delta-xero

Reduced iron levels and lower PQ index

A 1.5 MW wind turbine gearbox showed persistent contamination risk despite routine oil analysis. To understand the true internal condition of the gearbox, debris captured inside an offline filtration unit was analysed after extended in-service operation. Standard oil samples alone were not showing the full extent of varnish, wear debris, and moisture present within the system.  

View Case Study
Off-shore Oil and Gas: Case Study 2

The Additive Myth Debunked

A long-term independent study was carried out by POLARIS Laboratories Europe to assess whether installing Delta-Xero filtration on a landfill gas engine would negatively affect lubricant condition, additive performance, or expected oil drain intervals.

View Case Study
contact us

Ready to transform your oil management?