Coloured plastic pellets pouring into an injection moulding hopper

Housewares Injection Moulding: 99% Fewer Particles in 55 Days

Hydraulic fluid contamination reversed in 55 days: ISO 25/20/14 to 15/13/10 and MPC from 63.4 to 1.6.

Coloured plastic pellets pouring into an injection moulding hopper
case study

How offline filtration recovered severely oxidised injection moulding hydraulic fluid

The Challenge

A housewares manufacturer in the United States ran an injection moulding system from a 250 US gal (approximately 946 litre) reservoir of AW 46 hydraulic oil described as severely oxidised. Analysis showed elevated MPC, moisture, particle count and Total Acid Number, meaning varnish risk, water contamination and abrasive particles were all present at once.

Contaminated oil would keep circulating through valves and pumps, while oxidation and moisture could speed up deposit formation and shorten component life. The assessment was carried out by an independent third party, so site cost and production data were not supplied.

The Solution

A Delta-Xero offline filtration system was applied to the reservoir for 55 days, with continuous kidney-loop circulation through submicron cellulose media targeting fine particles, moisture and oxidation-related contaminants while the hydraulic oil stayed in service.

The reported data compared particle counts at ≥4, ≥6 and ≥14 µm, ISO cleanliness, water content and MPC before and after treatment.

The Results

  • Over 99% fewer fine particles: ≥4 µm particles fell from 183,677 to 222 per mL and ≥6 µm from 8,688 to 65.

  • Large particles: ≥14 µm particles fell by 83%, from 90 to 15 per mL.

  • Varnish removed: MPC fell from 63.4 to 1.6.

  • Less water: water content fell by 43%, from 51 to 29 ppm.

  • Cleaner oil: ISO cleanliness improved from 25/20/14 to 15/13/10, indicating more than ten times estimated component life.

Download the full housewares injection moulding case study for the complete data.

Related Case Studies

About us - Delta-xero

Reduced iron levels and lower PQ index

A 1.5 MW wind turbine gearbox showed persistent contamination risk despite routine oil analysis. To understand the true internal condition of the gearbox, debris captured inside an offline filtration unit was analysed after extended in-service operation. Standard oil samples alone were not showing the full extent of varnish, wear debris, and moisture present within the system.  

View Case Study
Off-shore Oil and Gas: Case Study 2

The Additive Myth Debunked

A long-term independent study was carried out by POLARIS Laboratories Europe to assess whether installing Delta-Xero filtration on a landfill gas engine would negatively affect lubricant condition, additive performance, or expected oil drain intervals.

View Case Study
contact us

Ready to transform your oil management?